Merivon
Fungicide
Active ingredient(s): Fluxapyroxad 21.2% w/w, Pyraclostrobin 21.2% w/w
Formulation: Suspension concentrate (SC)
Benefits
- Broad spectrum control: White rust, Gray mold.
- Rain fastness: excellent adhesion and spreading.
- Protect flower.
<h3 style="color: rgb(146, 208, 80);">Crop Suitability</h3>
-
<h4>Chrysanthemum</h4>
Target Disease
Pesticide Rate
per 10L Water
Pesticide Rate
per hectare
Spray Volume
per hectare
Maximum number of sprays
White Rust
2.5 ml
250 ml
1000 liter
2 times per season
Grey Mold
2.5 ml
250 ml
1000 liter
2 times per season
Prohibited Period of Re-entering the Treatment Area (REI): 24 hours
Product application information:
- Mixing Guide:
It is recommended to use a sprayer with a 'hollow' cone nozzle. Fill the tank half full with clean water. Mix Merivon adequately according to the recommendations set out in the dosage table then mix it. Next add the remaining clean water required and stir. Do not use at a higher rate than recommended. Do not store the remaining Merivon mixture in the sprayer tank.
- Spraying Guide:
Spray when signs of illness begin to appear. For good control, spray thoroughly onto the upper and lower surfaces of the leaves. Repeat the spray once every 14 days, only when necessary. If treatment needs to be repeated, use Merivon alternately with fungicides from different groups that have different modes of action.
5 Golden rules when handling Crop protection products:
- Read product label before use.
- Always check and ensure that spray equipment are in good working condition.
- Make sure to wash and clean right after spraying.
- Always be careful and maintain caution in using any crop protection products.
- Always use appropriate PPE during mixing and application: gloves, goggles, long sleeves, long pants, rubber boots, hat.
